Author Topic: changing gearbox oil (Read 2258 times)

a.12912 · « **on:** March 16, 2009, 12:21:37 AM »

spent an afternoon replacing all shift linkages and blown clutch master-cylinder, so wile i was under there i figured I'll do the box oil also.

problem being the big 17mm inverse hex nut / allen bolt wont budge!!

any ideas how to get the thing to move??

cheers

xwill112x · « **Reply #1 on:** March 16, 2009, 01:56:31 PM »

vice grips work well, get someone extra to push on those while you work with the ratchet.

P. Kennedy · « **Reply #2 on:** March 16, 2009, 06:24:00 PM »

When my ratchet handle alone doesn't allow enough leverage, I have a galvanized pipe maybe 2 ft. long and large enough in diameter to slide over the ratchet handle. Leverage = Good. Let physics work for you!

If my 2 ft. pipe doesn't do it, I have 5 ft. barbell handle that I can secure onto a breaker bar. That has never failed me.

Jimmy Lewis · « **Reply #3 on:** March 16, 2009, 06:48:51 PM »

Penetrating lube and leverage are your friend. I think I used a 17mm nut I had laying around, stuck it in a shallow socket and just used a 1.5ft breaker. It came out fine for me, but if it did give me trouble I would have broken out the 3ft breaker bar and some penetrating lube, always does the trick.