1
Vendors / GB / COP Conversion Brackets
« on: March 05, 2009, 03:18:19 PM »
Yes I will, You need to check which coils you have now though.
Here is the write-up for the later style.
Here is the write-up for the later style.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
2
General Topics / Need some help from the M24 forum
« on: March 01, 2009, 07:05:42 PM »
Sorry about your luck.
Where are you located?
If it were me, i would pull the entire driveline, seats, doors, dash, cluster, wheels, trunk (at least the spoiler), fuel pump, and fog lights.
what do you mean "go up 8?"
Where are you located?
If it were me, i would pull the entire driveline, seats, doors, dash, cluster, wheels, trunk (at least the spoiler), fuel pump, and fog lights.
what do you mean "go up 8?"
3
Suspension / rally or offroad suspension?
« on: February 25, 2009, 02:49:11 AM »Quote from: tony92ic;67177
I agree with Haledj on the springs, but the Bilstein Sports are shorter. They are designed for lowering springs. Go with the Bilstein HD.
good call
4
Suspension / rally or offroad suspension?
« on: February 24, 2009, 03:43:01 AM »
How about H&R OE sports? About stock ride height but stiffer. I would pair them with bilstein sports.
5
Engine + Driveline / COP on E36 318is
« on: February 23, 2009, 06:19:58 AM »
Yes you can, even on the later models it can be done without cutting up the harness.
6
Swaps, Turbos, Buildups / DISA+turbo in M43
« on: February 22, 2009, 02:27:53 AM »
I would use the e30 intake manifold and leave the Disa disconnected.
Edit, Nevermind I don't know anything about the m43.
Edit, Nevermind I don't know anything about the m43.
9
Engine + Driveline / New Car: BIG cold start problems
« on: February 10, 2009, 12:41:38 AM »
Sounds like a coolant temperature sensor
10
Swaps, Turbos, Buildups / My modded subframe
« on: February 05, 2009, 10:48:51 AM »
are you going to have to shorten the driveshaft?
11
Exterior / lemmie see your lights
« on: February 05, 2009, 10:45:40 AM »
I have lights on my roof rack, I'll see if I can get any pictures, all the ones I have are film.
12
Engine + Driveline / Electric Fan Thoughts...
« on: January 24, 2009, 05:29:38 PM »Quote from: tjts1;65302
Theres no point to this. Its really easy to setup an electric fan to run off the existing circuit and temp switch. All the information is already in the forum.
+1
13
Engine + Driveline / My new seized LSD
« on: January 22, 2009, 11:33:03 PM »
you might be able to put the LSD mechanism into a good open 4.10 diff.
14
General Topics / ?'s for those that have done the COP conversion
« on: January 08, 2009, 12:17:48 PM »
Coils should look like this, and the PN is 12131748018.
15
General Topics / ?'s for those that have done the COP conversion
« on: January 08, 2009, 12:15:47 PM »
I wash my engine regularly, and I have never had an issue. I suppose it is possible to get water down there, but you would almost have to try.
Yes, you will want to use the coils that have a round body with 2 mounting ears. The square ones will not fit. I'll get the PN in a second
I used a cutoff wheel to remove it, and then an angle grinder to clean it up.
Yes, you will want to use the coils that have a round body with 2 mounting ears. The square ones will not fit. I'll get the PN in a second
I used a cutoff wheel to remove it, and then an angle grinder to clean it up.