Author Topic: Replaced faulty sensor- CEL turned off but code remains (Read 2693 times)

ThisIsTheRanger · « **on:** March 13, 2009, 05:46:24 PM »

I just replaced my AFM with a used one because I was getting code 1224-Intake Air Temp Sensor. The check engine light went out as soon as I started it up again but when I check for codes with the stomp method, I still get code 1224. Do I have to reset the computer to get the code to go away? I tried unplugging all of the injection control fuses for a while to no avail. I figure the new AFM has a working IAT because the light went out but what's with this code?

JP 91iS · « **Reply #1 on:** March 13, 2009, 06:30:53 PM »

I remember reading about a way to clear the fault codes stored in the ecu. I don't remember how though. I would try disconnecting the battery for a few minutes.

RED IS 91 · « **Reply #2 on:** March 14, 2009, 04:01:20 AM »

Disconnect the Battery for 30 minutes .This should reset the computer.

ThisIsTheRanger · « **Reply #3 on:** March 15, 2009, 11:07:28 AM »

Thanks guys. That worked. I just didn't want to lose my stereo settings but for some reason they stayed. Now get code 1444