Author Topic: COP Conversion Brackets (Read 65207 times)

P. Kennedy · « **Reply #30 on:** October 12, 2007, 12:25:23 AM »

Anyone know if these coils will work, or is this too good to be true?

http://cgi.ebay.com/ebaymotors/BMW-E46-X5-X3-Ignition-Coil-Original-Parts-NoReserve_W0QQcmdZViewItemQQcategoryZ33689QQihZ015QQitemZ250173642910QQrdZ1QQsspagenameZWDVW

vitesse · « **Reply #31 on:** October 12, 2007, 07:15:19 AM »

it doesnt look like those bolt down, so I would assume they wouldn't work. Those type push into the spark plug holes.

BrandC · « **Reply #32 on:** October 12, 2007, 12:27:42 PM »

Got mine in the mail yesterday, looks great.

haledj · « **Reply #33 on:** October 18, 2007, 11:01:25 PM »

bump, they are half gone!

aaron31182 · « **Reply #34 on:** October 23, 2007, 08:53:03 AM »

Just got mine. Thanks!

haledj · « **Reply #35 on:** October 29, 2007, 07:34:25 PM »

Bump!

sports.racer · « **Reply #36 on:** December 03, 2007, 10:40:22 AM »

Check PM.

jakeb · « **Reply #37 on:** December 23, 2007, 08:40:59 PM »

Do you still have these?

haledj · « **Reply #38 on:** December 23, 2007, 08:42:57 PM »

yes, I do

bmwman91 · « **Reply #39 on:** December 23, 2007, 09:08:58 PM »

Hey, those look good! What did you polish the top with?

haledj · « **Reply #40 on:** December 23, 2007, 09:22:46 PM »

Thanks, I wetsanded it with a random orbital, then finished it on a bench polisher.

jakeb · « **Reply #41 on:** December 23, 2007, 09:33:14 PM »

Do you know which plug goes to each coil?
I am swapping into a 2002 and not everything on the harness is labeled. Two of the leads are together and the other two are on their own.

does this make sense?

jakeb · « **Reply #42 on:** December 23, 2007, 09:36:23 PM »

Also what is the little leg on the one end for? That sticks out past the valve cover, near the firewall.

D. Clay · « **Reply #43 on:** December 23, 2007, 09:47:01 PM »

The valve cover is wider at the top than where the original cover fit. I have had a new cover on my do list for some time but have never gotten around to it. It would be easy to secure it to the COP plate. I was going to get black plastic (heat resistant) and make one and try some different logos, etc. Unfortunately, I've always had two or three things on my to do list ahead of it. If any one else does something nice I would be interested in one.

haledj · « **Reply #44 on:** December 23, 2007, 10:02:49 PM »

Quote from: jakeb;39941

Also what is the little leg on the one end for? That sticks out past the valve cover, near the firewall.

It is to secure the wires leading to the coils, if you would like I can make one without.

Author Topic: COP Conversion Brackets (Read 65207 times)

aaron31182