« previous next »
Pages: [1]   Go Down

Author Topic: sway bar tabs  (Read 2982 times)

sha1234

  • Full Member
  • ***
  • Thank You
  • -Receive: 0
  • Posts: 109
    • View Profile
sway bar tabs
« on: September 09, 2007, 02:45:53 PM »
well the rear control arm tab where the sway bar mounts up has broken off... even after i bolted down the re inforcment tabs... so i picked up the TMS tabs that should be weldered....
BUT... since the rear control arm is apparently... cast? should i weld it a certain way... use a different gas or wire?
has anyone welded on this tab?
Logged

sha1234

  • Full Member
  • ***
  • Thank You
  • -Receive: 0
  • Posts: 109
    • View Profile
sway bar tabs
« Reply #1 on: September 09, 2007, 04:55:01 PM »
never mind... figured it all out... its a stamped peice so i can just weld her all up
Logged
Pages: [1]   Go Up
« previous next »