Author Topic: Ignition refrence (Read 2825 times)

Gunni · « **on:** January 22, 2007, 03:50:47 AM »

I�ve never belived my 115deg to be accurate especially when I�ve needed to dial in more advance , it was in the high 30�s at WOT and high 40�s in low load,

But I was reading and my xms reads the ignition refrence from the cam shaft sensor and not the timing wheel, so I guess I need to put the sensor and mark on the same spot and then calculate the numbers of the timing wheel,
So I guess I need to double check everything,

And can you guys verify that the Arrow mark on the chain cover and a little mark in the timing wheel line up at TDC??

bar73k · « **Reply #1 on:** January 22, 2007, 05:19:15 AM »

Quote from: Gunni;17988

And can you guys verify that the Arrow mark on the chain cover and a little mark in the timing wheel line up at TDC??

Yes the arrow mark on the chain cover and mark on the timing wheel line up
at TDC..... im 95% sure.

Gunni · « **Reply #2 on:** January 22, 2007, 05:51:44 AM »

What are your settings?

bar73k · « **Reply #3 on:** January 22, 2007, 11:36:25 PM »

Quote from: Gunni;17997

What are your settings?

what do you mean by that?

Gunni · « **Reply #4 on:** January 23, 2007, 03:09:54 AM »

what are the ignition settings in your engine management,
just post them all and while your at it, why don�t you post all the info into here
http://www.m42club.com/forums/showthread.php?t=1678

bar73k · « **Reply #5 on:** January 23, 2007, 05:01:28 AM »

i left my laptop at work today, ill have a look tomorrow an see what i can get off it.