Author Topic: DIY engine tools (Read 3272 times)

ToniBmwPortugal · « **on:** April 20, 2012, 07:55:03 PM »

Hi there to all!
I've been reading and reading on this forum and i got to a point that i've decided to make/rebuild my own engine.
But this lead me to a problem: what tools are necessary...
So i started this thread to we discuss about the tools: specialized (BMW) or not that are required to work on our cars, especialy the engine. The idea is to make a list with the tool and the function to what is required.

P.S. I'm sorry for the bad english (i,m a Portuguese guy)

List with tools:

-flywheel lock (pin part # 83-30-0-490-861)
-camshaft holding tool
- ...

DanOKC · « **Reply #1 on:** April 21, 2012, 02:08:13 AM »

flywheel lock pin part # 83-30-0-490-861,
and camshaft holding tool.

ToniBmwPortugal · « **Reply #2 on:** April 21, 2012, 06:14:23 AM »

Quote from: DanOKC;112030

flywheel lock pin part # 83-30-0-490-861,
and camshaft holding tool.

ok that's a start

d.hitchcock · « **Reply #3 on:** April 21, 2012, 10:44:28 AM »

Thin or flat 32-mm open-end wrench for removing the fan clutch.

A hub holder to aid in removing the fan clutch.

Peake inspection light reset tool.

DesktopDave · « **Reply #4 on:** April 21, 2012, 12:50:08 PM »

You'll need a long torx socket for the head bolts too, from what I've heard.

bmwman91 · « **Reply #5 on:** April 21, 2012, 06:33:03 PM »

Pipe fittings can be machined (sort of requires a lathe) to install rear subframe & trailing arm bushings.

The crank bolt is super easy to loosen...you just need a 4"x4" block of wood and a breaker bar. You then use the starter motor to smack the bar into the wood block until it comes loose.

Tightening that bolt requires some sort of locking tool. I made one out of some 1/2" thick steel plate and a drill press (bolts to the 6 accessory pulley holes, rests against same wood block on driver's side that was used to break it loose).

wazzu70 · « **Reply #6 on:** April 21, 2012, 06:41:20 PM »

Quote from: DesktopDave;112039

You'll need a long torx socket for the head bolts too, from what I've heard.

Yes, you need a long thin torx head socket to remove the head bolts with the cams in place.

Technically you are supposed to have a tool to loosen the cam bearing caps. You can also remove the caps without the tool by Loosening/tightening the nuts in a star pattern from the center 1/4 turn at a time. Takes a while, but if you go too fast the hollow cam can snap!

deansweet · « **Reply #7 on:** April 22, 2012, 12:24:39 PM »

bmw p/n for head torx bit tool is 83-30-0-490-856-BOE

It's a bit pricey, there's an OEM version one you can pick up at autozone.com for $30?