Author Topic: wtb: m20 flywheel/clutch/starter (Read 3880 times)

jakeb · « **on:** February 14, 2011, 11:23:29 AM »

Looking for a m20 flywheel or 323, clutch, and a m20 starter to do the swap onto a m42.

TIA, jake

DesktopDave · « **Reply #1 on:** February 14, 2011, 04:55:57 PM »

If you find a later model M20 flywheel ('89 or later IIRC) you won't need the starter since the teeth are the same as the M42. I have an older model M20 single mass & starter if you're interested and local. I'll bet it goes 40 pounds all up. Shipping would be murder.

I think that the M42 or M40 non-A/C clutch might be a good deal for you too, if you can find one. I'm pretty sure they were offered in Canada and you know it'll fit perfectly. That's the only single-mass offered for the M42 in North America. I'll post a link if I find one.

This is all I found so far:
http://www.318ti.org/forum/showthread.php?t=11586&page=2

I'll be looking for more.

jakeb · « **Reply #2 on:** February 15, 2011, 06:49:33 AM »

Shipping actually isn't bad because you can fit the flywheel in a flat rate USPS box as well as the starter in another. I shipped 3 m10 clutches with pressure plates in one $11 flat rate box.

DesktopDave · « **Reply #3 on:** February 15, 2011, 07:54:42 PM »

That might work. Let me know if you're interested, I can post some pics of the flywheel & pressure plate.

jakeb · « **Reply #4 on:** February 15, 2011, 08:35:38 PM »

send me a PM with price and any other info

thanks

redhead · « **Reply #5 on:** March 23, 2011, 05:43:00 PM »

I have an m20b25 flywheel & starter motor if you are still interested.