Author Topic: Timing question... (Read 6595 times)

beemer1 · « **Reply #15 on:** March 25, 2009, 12:39:18 PM »

Yeah that would have been a better idea but I needed the car finished ASAP as its my main mode of transportation. I used sea foam in a spray bottle with an old tooth brush and some rags. Let the sea foam soak and it came out pretty clean with some elbow grease.

I gotta say using mobil-1 for 10+ years sure as heck kept the motor clean. No sludge build up:)

1991 E30 M42 · « **Reply #16 on:** March 25, 2009, 01:44:07 PM »

btw a beemer is a motorcycle a bimmer is a car

beemer1 · « **Reply #17 on:** March 25, 2009, 02:01:12 PM »

Quote from: 1991 E30 M42;68897

btw a beemer is a motorcycle a bimmer is a car

LOL, I hate when that happens! When I was making my screen name I was in the middle of the whole timing chain debacle and needed advice quickly. Now that you said it I do remember that, oops

1991 E30 M42 · « **Reply #18 on:** March 26, 2009, 12:03:13 AM »

i have plenty of brain farts like that

bbarnumboy · « **Reply #19 on:** April 21, 2009, 10:51:39 PM »

where exactly is the tdc flywheel hole located at? i cannot find it and i am doing my head gasket right now. also if i do not have the official tool what is the correct size of the rod to put in the hole? width wise. thanks guys.

nicknikolovski · « **Reply #20 on:** April 22, 2009, 03:12:40 AM »

Flywheel hole is right underneath starter motor and when the flywheel pin goes in, it will sit right up against the block. You can't miss it - just have a good look. If you haven't got the tool, use an 8mm drill bit.

What about the cams? Have you got the locking tool for the camshafts?

nicknikolovski · « **Reply #21 on:** April 22, 2009, 03:15:50 AM »

Also beemer1

Quote

Nick by the way are you Macedonian? If so dobar dan e hvala, thanks again!

Steve

Yes I am and Nema greshka

bbarnumboy · « **Reply #22 on:** April 22, 2009, 04:20:50 PM »

no cam tool but i made one thanks for the information :-)