Author Topic: torque wrenchs? (Read 2918 times)

doitover · « **on:** September 30, 2008, 12:29:02 PM »

I need a low range torque wrench due to the low torque specs on this thing. I haven't had much luck in finding anything. What are people using?

kowalski · « **Reply #1 on:** September 30, 2008, 12:33:38 PM »

snap-on, craftsman prof. Blue point, Jet, etc... all have/make torque wrenches.

http://www.sears.com/shc/s/search_10153_12605?keyword=torque+wrench&gobutton.x=0&gobutton.y=0&gobutton=find

Birdman16 · « **Reply #2 on:** October 01, 2008, 04:09:45 PM »

I have a Craftsman for tightening things like air plenums and valve cover bolts. God only knows how many times I've done this....

ak96ss · « **Reply #3 on:** October 01, 2008, 06:44:04 PM »

I use a couple-decades-old Craftsman beam torque wrench for that stuff. It isn't terribly precise, but it works pretty well.

kowalski · « **Reply #4 on:** October 02, 2008, 12:46:20 AM »

is that the one with the big dial on it, and you measure the torque by the flex?

ak96ss · « **Reply #5 on:** October 02, 2008, 01:35:29 AM »

Yep, that's it.

keflaman · « **Reply #6 on:** October 02, 2008, 06:00:45 AM »

I bought a set of "click" type torque wrenches from HF a few years back. I used them on my personal projects for 2-3 years and one day out of curiosity I took them into the calibration lab where I worked and asked to have them checked just for S&G.

I was quite surprised to find they were well within specification and the lab tech said he was somewhat impressed with the build quality, especially considering what I had paid for them.

JP 91iS · « **Reply #7 on:** October 02, 2008, 02:24:27 PM »

Quote from: keflaman;57735

I bought a set of "click" type torque wrenches from HF a few years back. I used them on my personal projects for 2-3 years and one day out of curiosity I took them into the calibration lab where I worked and asked to have them checked just for S&G.

I was quite surprised to find they were well within specification and the lab tech said he was somewhat impressed with the build quality, especially considering what I had paid for them.

That's good to know. I've been needing to pick one up and I always eye-ball the ones at HF. I just didn't know if I could trust them. I wonder if the build quality has gone down in the years since you bought yours.

doitover · « **Reply #8 on:** October 02, 2008, 02:32:15 PM »

I've heard similar stories about Northern Tool. I didn't think to try HF but I've had a difficult time finding a wrench that covered the low range the M42 requires. I ended up ordering one by Gearwrench through Amazon. Can't comment on it, it isn't here yet.

Quote from: JP 91iS;57754

That's good to know. I've been needing to pick one up and I always eye-ball the ones at HF. I just didn't know if I could trust them. I wonder if the build quality has gone down in the years since you bought yours.