« previous next »
Pages: [1]   Go Down

Author Topic: Axle shafts wont go in  (Read 2046 times)

EN318isPDX

  • Hero Member
  • *****
  • Thank You
  • -Receive: 0
  • Posts: 650
    • View Profile
    • http://www.cardomain.com/id/ItotheAtotheN
Axle shafts wont go in
« on: May 27, 2008, 05:00:37 PM »
how do i get them to slide into the wheel bearings i got one but the other side stopped about 2/3 of the way in.
Logged
WTB 97+ M3 Front Strut Assembly and 97+ M3 Control Arms (caster is important)
WTB Driver side Diamondschwartz fender PST

szed03

  • Jr. Member
  • **
  • Thank You
  • -Receive: 0
  • Posts: 88
    • View Profile
Axle shafts wont go in
« Reply #1 on: May 30, 2008, 12:15:27 PM »
Did you clean the splines of any surface rust or gunk?  Maybe a wire wheel will do the trick.
Logged

EN318isPDX

  • Hero Member
  • *****
  • Thank You
  • -Receive: 0
  • Posts: 650
    • View Profile
    • http://www.cardomain.com/id/ItotheAtotheN
Axle shafts wont go in
« Reply #2 on: May 30, 2008, 09:48:08 PM »
Ended up figuring it out. Even with my suspension fully maxed out the diff wasnt level with the wheel bearing. Had one of my "bigger" friends sit on the trunk while i slid it in. What a bitch it turned out to be! Glad I wont be doing CV's again anytime soon
Logged
WTB 97+ M3 Front Strut Assembly and 97+ M3 Control Arms (caster is important)
WTB Driver side Diamondschwartz fender PST
Pages: [1]   Go Up
« previous next »