Author Topic: Brake pad wear sensor (Read 2427 times)

Cobra Jet · « **on:** February 27, 2008, 08:41:20 AM »

Why do some owners of 318's disconnect, cut or don't use the brake pad wear sensors? I have seen multiple threads where folks who bought a used 318 have discovered disconnected or cut brake pad wear sensors and have come across some threads where others just don't use them at all...

?

Is this just an "annoyance"?

tjts1 · « **Reply #1 on:** March 01, 2008, 12:44:03 PM »

Because most after market brake pads are not set up to accept the factory sensor. I got rid of mine too. Took all the wiring out too all the way back to the fuse box. Save a whole .01lb.

Choking Hazard · « **Reply #2 on:** March 01, 2008, 11:33:37 PM »

I figure people get annoyed by that light for a while, and they are told or they realize they can bypass it so they just take it out.
If mine had been diconnected, I wouldn't have done an uneccessary brake job when my non-oem starter install caused the light to glow all the time.

RED IS 91 · « **Reply #3 on:** March 02, 2008, 07:51:52 AM »

I just pulled the bulb out of the cluster .