Author Topic: not an e30...but an m42 none the less  (Read 6215 times)

jakeb

  • Full Member
  • ***
  • Thank You
  • -Receive: 4
  • Posts: 248
    • View Profile
not an e30...but an m42 none the less
« Reply #15 on: January 23, 2008, 04:36:13 PM »
Picked it up from the exhaust shop today and drove it to my storage unit where it will sit until it is warm...   Exhaust sounds good...it is quiet a bit louder than my e30 m42.  I am running 2.25" pipe through two magnaflow mufflers.  

Also right now I have a large hole in the firewall that the motronic cable is going through so I am getting a lot of engine noise and wind.  I stuffed a shirt in there and it helped a lot.

First reactions are I really like it.  I didn't really have a chance to really get on it.  As it was the first time driving it, it is 20 degrees outside and there is snow on the roads.  

No smoke or odd sounds from the engine, has around 160k on it.  

I cannot wait until it warms up and the roads get cleared off to really test it out.

It took a month from the time I started until I was running and driving.
http://www.classicdaily.net - swapping this into that
http://www.blunttech.com - all your parts needs

kowalski

  • El\' Duder
  • Administrator
  • Legendary
  • *****
  • Thank You
  • -Receive: 3
  • Posts: 1368
    • View Profile
not an e30...but an m42 none the less
« Reply #16 on: January 23, 2008, 07:21:48 PM »
how come you got a turbo header for it if its N/A? and where did you get it from?
Sale:
EBC Green stuff pads = $60 shipped front and rear set available


Send $ to: kroeker.michael @ gmail.com

Fore Sale Thread

jakeb

  • Full Member
  • ***
  • Thank You
  • -Receive: 4
  • Posts: 248
    • View Profile
not an e30...but an m42 none the less
« Reply #17 on: January 24, 2008, 06:10:00 AM »
Because there is very little room in the 2002 engine bay to fit the stock header.  I got the manifold off ebay, it is for a m5x/s5x.  I then cut two runners off and had a cap welded on.
http://www.classicdaily.net - swapping this into that
http://www.blunttech.com - all your parts needs

enildeR

  • Full Member
  • ***
  • Thank You
  • -Receive: 0
  • Posts: 173
  • lol ur face
    • View Profile
not an e30...but an m42 none the less
« Reply #18 on: April 17, 2008, 02:27:36 AM »
them roads clear up yet? :)

BrandC

  • Sr. Member
  • ****
  • Thank You
  • -Receive: 0
  • Posts: 306
    • View Profile
not an e30...but an m42 none the less
« Reply #19 on: April 18, 2008, 02:35:51 AM »
Wait hold on a second, so we can use M5x/S5x turbo manifolds (theoretically) to fab our own M42 turbo manifolds?

beegeezy

  • Full Member
  • ***
  • Thank You
  • -Receive: 0
  • Posts: 123
    • View Profile
not an e30...but an m42 none the less
« Reply #20 on: April 18, 2008, 03:29:48 PM »
yes.
It\'s not paranoia if they really are out to get you.

EN318isPDX

  • Hero Member
  • *****
  • Thank You
  • -Receive: 0
  • Posts: 650
    • View Profile
    • http://www.cardomain.com/id/ItotheAtotheN
not an e30...but an m42 none the less
« Reply #21 on: April 18, 2008, 05:14:46 PM »
The engine bay is lookin good.. hows the rest of the car coming along? You updating the interior?
WTB 97+ M3 Front Strut Assembly and 97+ M3 Control Arms (caster is important)
WTB Driver side Diamondschwartz fender PST