Low beams work fine. Turning on the high beam switch results in both hi & lo being lit on the right side, and neither hi nor lo on the left side. Any ideas? Thanks in advance,
Drew Z.
Did you solve this ? This same thing happened to me.........
I found 2 problems. The fuse for the high beam, was blown. Fuse # 2 for me. But I had the reverse problem, the Left lights worked fine and the right lights would die if I switched to high beams. Which would make it fuse # 1 I think, for you.
The second place to look is the connector at the back of the light switch. Corrosion on one terminal, caused my low beams to work fine but when I turned on the lights, low beams would die and the high beams could be turned on or off by the beam selector switch. Good luck !