Author Topic: profile gasket & upper pan gasket (Read 2852 times)

mabeer · « **on:** March 03, 2013, 03:19:33 PM »

In the process of refreshing my timing components I noticed my profile gasket looks like my gut hanging over my beltline.

And my upper pan gasket is similar

Do you advise replacing? Probably a stupid question but on the off chance I might save a bunch of work I'd thought I'd ask.

Thanks
Mike

DesktopDave · « **Reply #1 on:** March 03, 2013, 07:22:09 PM »

IMHO better now than later. The profile gasket does tend to squeeze out a bit, even when it's good. Post some pics if you get a chance.

deansweet · « **Reply #2 on:** March 03, 2013, 07:49:07 PM »

original post is AWOL...

mabeer · « **Reply #3 on:** March 03, 2013, 07:52:20 PM »

Don't know where the post went. I tried to post pics and they were just red x's. Went back to try and edit and poof post gone. I'll try later. Thanks

mabeer · « **Reply #4 on:** March 03, 2013, 07:59:32 PM »

Lets try this, profile gasket

and upper pan

mabeer · « **Reply #5 on:** March 03, 2013, 08:01:25 PM »

Hmm, not sure what's wrong. My apologies.

mabeer · « **Reply #6 on:** March 03, 2013, 08:25:24 PM »

Maybe I need administrator approval. Just tried again. Post appeared, albeit with broken picture links, now it is gone too.

DesktopDave · « **Reply #7 on:** March 04, 2013, 02:15:46 PM »

I approved your posts, not sure where the links went.