FS: PNW M42 Heads, Complete Engine, Transmission

[Carter]

So...I think it's time to liquidate some of the M42 stuff I've been hoarding.

I have 3 cylinder heads.  One is off an E36 so it has a slightly different valvetrain but bolts on the same.  I have not had any of them pressure checked,  but visually I cannot see any cracks and they come out flat with the straight edge.  If you buy one, (or 3!), get it tested, and it's cracked, I'll give you your money back, I don't want to leave anyone SOL with scrap aluminum, you'll be out the pressure test $$, that's all. As you can see, only one comes with cams/trays but the rear lobes are scored pretty bad. One free valve cover to whoever buys the first head!
$150 each

Make me some offers, I'm not in a rush to sell these, but I do want them gone!  Thanks!

Image link here: http://imageshack.us/g/841/p1030502va.jpg/

[DesktopDave]

Approved!  GLWS...good prices here.

[Shangsta]

very good prices

[Carter]

Need beer money bump!

[Geoff]

you're supposed to say, "need beer money..burp.."   thats ok you are only one letter off
                                  Geoff

[Carter]

Considering parting out motor as well. Make me some offers.

[Carter]

Engine/Trans gone!

[Carter]

Bump 1 head sold today.

[ghiagern]

Hi Carter,
 I recently acquire a 96 318ti with cracked head.:mad: Found out today somebody replaced the m44 motor with a m42.:confused: The head was cracked, so I need to replace it, but not sure which of yours would be best. I assume you still have 2 left.

Thanks
Rob

[ghiagern]

Hi Carter,
The head I need to replace was a 1721464 casting.
Rob