Author Topic: Parting out complete M42 engine from a 91 - CA (Read 5149 times)

Niterider11 · « **on:** January 10, 2011, 09:55:53 PM »

Hey everyone I have for sale every part from a 91 M42 minus starter, flywheel and cylinder head. Cylinder head was cracked so I ended up swapping in a new engine. Had 154k on it when I took it out. I will post pics tomorrow, if interested in any parts let me know. Also willing to trade for interior parts such as seats door panels carpet and center console

DesktopDave · « **Reply #1 on:** January 10, 2011, 10:12:59 PM »

I wish you were closer. Shipping big bits like door cards cross-country will be expensive. I'd be interested in the timing case, especially if the cam gears are good.

I have some late model sedan tan fabric panels that are in OK shape. I know I have a few center consoles from sedans too.

Niterider11 · « **Reply #2 on:** January 10, 2011, 10:16:29 PM »

I havent even looked at gears but I will tomorrow and post pics for you. Sorry looking for black or grey interior

Gerta318is · « **Reply #3 on:** January 14, 2011, 03:05:32 PM »

I have a set of door panels and sun visors (passengers and drivers side). Id be interested to know if you have the complete battery hold down set up.

timc1018 · « **Reply #4 on:** April 17, 2011, 08:56:22 PM »

looking for a dual mass flywheel for my son's 91 318is (M42)...

DesktopDave · « **Reply #5 on:** April 17, 2011, 09:10:14 PM »

Timc1018 - Hate to say it but you might have some better luck over at r3v...if you haven't done it already, that is. Sadly, a lot of M42's get swapped out over there, you're sure to get one or two reasonable offers.

Have you considered the single-mass conversion? You might want to PM JoeDelio from this thread (M50 flywheel setup). Great price IMHO.

91318isfoundation · « **Reply #6 on:** April 23, 2011, 06:48:53 PM »

hey how much would u want for the lower and upper oil pans along with the pickup tube and all the other macaroni in the oil pans

BimmerJon · « **Reply #7 on:** April 26, 2011, 11:47:51 PM »

Interested in the crank pulley if you have it! Thanks!

e30work · « **Reply #8 on:** May 06, 2011, 10:20:55 PM »

you got PM

sailer6460 · « **Reply #9 on:** August 28, 2011, 10:21:09 AM »

PM sent

M5wanaB · « **Reply #10 on:** August 28, 2011, 12:42:19 PM »

looking for an exhaust cam and tray as long as it does not have any scoring on the journals.

Brink · « **Reply #11 on:** August 28, 2011, 01:47:36 PM »

Interested in the whole bottom end, pm'd you