« previous next »
Pages: [1]   Go Down

Author Topic: minimum wiring to run e36 m42 with 990 dme  (Read 2976 times)

m42240z

  • Newbie
  • *
  • Thank You
  • -Receive: 0
  • Posts: 1
  • Freshly Registered!
    • View Profile
minimum wiring to run e36 m42 with 990 dme
« on: April 30, 2016, 09:43:06 PM »
i have an m42 in my datsun and started the wiring. i have 12v from ign to dme (via relay) through the x20 main harness. grouns are secured and main/fuel pump relays are getting voltage to pin 30 but fuel pump will not prime when ignition is switched on. any ideas?
Logged

Delta

  • Newbie
  • *
  • Thank You
  • -Receive: 2
  • Posts: 30
  • Freshly Registered!
    • View Profile
Re: minimum wiring to run e36 m42 with 990 dme
« Reply #1 on: May 03, 2016, 03:49:30 PM »
In the e30 the fuel pump does not prime until the motor is cranking. If you have it wired the same way then it will not prime with the ignition on.
Logged
Pages: [1]   Go Up
« previous next »