Author Topic: How tight to make the belts? (Read 2245 times)

nomad · « **on:** August 13, 2007, 07:47:51 PM »

I replaced the belts and everything's cool but I'm wondering how tight I should have made them. I don't want to put undue pressure on the waterpump shaft bearing or the PS pump etc.

I'm thinking I may back them off some and see if I get any slippage.

Any "rule of thumb" to go by?

rhogg · « **Reply #1 on:** August 13, 2007, 08:16:24 PM »

A number of the DIYs suggest 1/4" deflection. I found this too tight. Trial and error to find the softest setting that didn't squeal was what I did. Keep track of the notches on the tightening track as you do this, and you'll have it dialed in in a couple of attempts.

Shocker · « **Reply #2 on:** August 13, 2007, 10:37:49 PM »

The factory adjusters will strip out way before you get your V belt to tight. As long it doesn’t squeal its fine. 1/4” play/Deflection is perfect.

nomad · « **Reply #3 on:** August 14, 2007, 09:26:25 AM »

Guess I'll back them off slightly then.

And yes, those factory adjusters are rediculous.