Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - brent5631

Pages: [1]
1
Engine + Driveline / Mustang Injectors in an M42 engine
« on: October 03, 2012, 11:23:19 AM »
So after bein confused by this whole thread is there any consensus on a replacement injector for a stock m42? One that doesn't leak and seats correctly and flow the right amount.

2
Engine + Driveline / Idle issue
« on: September 19, 2012, 10:38:12 PM »
I haven't noticed any lost coolant.

It seems to me that the car is stuck in the higher idle mode for having the ac on even when the ac is off. But I don't know what triggers the change or how to troubleshoot that.

3
Engine + Driveline / Idle issue
« on: September 18, 2012, 09:03:01 PM »
I replaced the cable and the intake boot when I first got the car. Also when I first start the car it will sometimes idle about 800 which seems right. Then after driving it will stay up about 1100.

4
Engine + Driveline / Idle issue
« on: September 16, 2012, 09:40:32 PM »
So I replaced all the vacumn hoses doing the mess under the intake mod. Also swapped the o2 sensor and cleaned the icv which looked liked it has been replaced before it was pretty clean. So that fixed the jumping idle but it still seems high idling about 1100. Also when the ac is on it lowers to about 800 but when it cycles off it is right back to 1100. What else should I check? It's not a big deal just want it to be right.

5
WTB/WTT / Wtb: non premium sound radio
« on: July 08, 2012, 03:30:52 PM »
Looking for a stock radio for a non premium sound car. It needs to work at least the am and fm don't care about the tape deck so much. Let me know.
Let me know what you have and I send you some money.
Thanks

6
Engine + Driveline / M42 Thrust Bearing
« on: June 21, 2012, 07:48:31 PM »
Hey guys,
I just got a 91 318i a few weeks ago. I've been reading about all the mechanical things to watch out for. Question is can this bearing be replaced without pulling the motor or crank?
And is it worth it to do it?
I still haven't checked the endplay so this could all be for nothing.
Let me know what you think.
Thanks

Pages: [1]