Show Posts

1

For Sale / Husco armrest

« on: December 02, 2010, 01:31:36 AM »

Put this thing up on eBay.

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=300499824831#ht_500wt_1182

2

General Topics / M44 into E30?

« on: February 18, 2009, 11:19:01 AM »

Hey guys. I got a cheap M44 ($300) that has lower miles than the engine in my car. Besides swapping out the intake manifold what would I have to do to make this engine work in my car. Will my ECU work with this engine?

3

Engine + Driveline / Pulling my oil pan, what to look for

« on: January 06, 2009, 08:04:52 PM »

Replaced the pan yesterday. Didn't find any bolts in the pan and when I looked up to see if there were any empty holes I didn't see any.

This motor has been through a lot. I've ran it low on oil, twice. Drove for half a mile with oil pouring out of the pan. And forgot to tighten the oil filter cap when I started the car so tons of oil came out and the engine ran for 5 or so seconds. 233,000 miles and the damn thing is still going!

4

Engine + Driveline / Pulling my oil pan, what to look for

« on: December 31, 2008, 09:42:06 PM »

Thanks for posting that link. Definitely going to have to give my motor a good once over.

5

Engine + Driveline / Pulling my oil pan, what to look for

« on: December 31, 2008, 02:28:56 PM »

Thanks a lot doyle. Exactly the information I was looking for.

6

Engine + Driveline / Pulling my oil pan, what to look for

« on: December 31, 2008, 01:19:38 AM »

So I punched a fairly big hole in my pan the other day. Turned off the motor before it seized so I'm ok there. I remember reading a while back that some people find bolts in their oil pan when they pull it, where are these from and how crucial is it that I put them back?

I also need to know the torque specs of the oil pan bolts.

Thanks.

7

General Topics / Official Dynolicious Results Thread

« on: December 15, 2008, 05:41:40 PM »

I've had this program for my 3G since it came out, and still haven't used it. Whoops.

8

General Topics / Pics from meet in Floral Park Queens

« on: September 03, 2008, 03:25:04 PM »

Oh god I just noticed that some of the interior bits are painted Phoenix Yellow too.

9

General Topics / Pics from meet in Floral Park Queens

« on: September 02, 2008, 09:13:04 PM »

Take motor and anything related to it and drop it in a new car. Then it would be good. That shell is horrible.

10

Engine + Driveline / just got my magnaflow

« on: July 10, 2008, 01:24:22 AM »

Alright so I just received my Magnaflow muffler/tip and have a question about installation. On the last day of school I weighed my car and pulled the muffler at the cat (2600lbs dry). I've been running like that for almost 4 weeks now and am starting to get tired of the massive vibrations and how it's too loud.

So my question is how to install the muffler. If I just cut the stock muffler off and weld the Magnaflow on will the two straps that went around the stocker work on the MF? Just wondering how you guys did it...

11