Messages

1

For Sale / white 318i $1800 in north nj

« on: February 23, 2012, 11:38:50 AM »

The pics are showing up on my side... and I even checked on my other comp... I can try emailing them to you

2

For Sale / white 318i $1800 in north nj

« on: February 23, 2012, 11:05:14 AM »

i really wish i could keep it... but with having a baby girl and trying to buy a house... i cant afford to keep it... so unfortunately it has to go... just like the bikes...

3

For Sale / white 318i $1800 in north nj ***pics added***

« on: February 20, 2012, 06:01:22 PM »

91 318i about 136k miles

Hate to see her go but I just had a baby girl


Complete front end done last year
 Remote start with alarm and pager
chipped ecu
Mess under intake done
Short throw shifter with dssr
Coil on plug conversion
Mustang injectors
Clarion head unit
Drilled And slotted brakes
Skid plate
2.5 inch drop tokico shocks and springs

The bad
Front bumper cracked on passanger side
Driver side fender could use replacing
Shifter getting sloppy (I have the bushings)

4

General Topics / vert fenders and sedan fenders???

« on: May 12, 2011, 08:54:22 PM »

are all e30 fenders the same???

is there any difference between coupe, sedan or convertible fenders???

im pretty sure there isnt but ive been searching and cant find the answer...

thanks
-alex

5

Engine + Driveline / Fuel pressure???

« on: December 24, 2009, 03:55:02 PM »

its getting crappy fuel mileage....it also kinda stumbles under three thousand rpm...

thanks for the input guys... much appreciated

6

Engine + Driveline / Fuel pressure???

« on: December 23, 2009, 05:19:31 PM »

what should my fuel pressure be???
i think i need a fuel pressure regulator

is it worth getting an ajustable fpr???
if so, would there be any noticeable gains from upping the fuel pressure???

i dont kno if this matters but.... i did the mess under the intake mod, mustang injectors, throttle heater plate delete.... and it has a k&n cone filter with heatsheild...

thanks for any help/opinions

7

Engine + Driveline / shift carrier bushing???

« on: October 27, 2009, 06:34:48 PM »

the rubber bushing that holds the rear of the shift "carrier" is beyond warn out.... the rubber completely deteriorated so its actually missing....

part number 25-11-1-220-707-M9



pelican parts has an oem one for like 30 bucks...


my question is... is there a urethane replacement for it???

every other part bushing, washer, and circlip have been replaced

i have tried searching for it but no luck on my part

8

For Sale / The Ultimate COP FS Thread

« on: October 16, 2009, 08:57:44 PM »

payment sent... thanks rob

9

For Sale / The Ultimate COP FS Thread

« on: October 11, 2009, 01:42:12 PM »

any COP kits yet???

10

Engine + Driveline / Selector Rod bushings???

« on: October 04, 2009, 10:22:03 PM »

so my shifter is getting a little on the sloppy side...

i took a look at the linkage and noticed that the play was in the selector Rod...

the little bushings are missing

is there any website that just sells those little bushing???

Maybe a urethane ones...

or should i look into the "Double Shear Selector Rod" from turner motorsports???
(they only list for the 325 is it the same???)

http://www.turnermotorsport.com/html/detail.asp?PRODUCT_ID=DSSR187

11

Engine management / PCIII Not GSXR

« on: October 03, 2009, 09:29:15 PM »

i kno that the last post here was in february... but how did the pcIII work on the m42???

12

Engine + Driveline / URGENT help: engine dies in neutral..

« on: September 29, 2009, 09:38:26 PM »

my car dies in neutral sometimes... like once a week...

test the ignition coils... i tested mine and two were out of spec... i cant remember the specs...  

maybe you have a weak coil

13

For Sale / The Ultimate COP FS Thread

« on: September 28, 2009, 12:26:42 AM »

pm sent