Replacing clock

[jpod999]

Ok well My clock had a HUGE leak in it, so I bought one off of eBay and replaced it today. Here's a tutorial on how to do it, it was way easier than I thought it would be.

Here is my clock:
http://img150.imageshack.us/img150/6365/pc090025gz5.jpg

Here is the new one:
http://img222.imageshack.us/img222/5425/pc090026ry8.jpg

Use a small flathead screwdriver and pry off the faceplate of the clock. It comes off very easily so apply just a little bit of pressure. Once you have the faceplates off press the two tabs at the top and bottom of the unit in the direction of the arrows:
http://img138.imageshack.us/img138/6107/pc090027lh3.jpg

Pull the unit out far enough so that you can see the back. Move the black lever up and the harness will come out:
http://img82.imageshack.us/img82/7603/pc090028un3.jpg

This might be a good time to replace the bulbs in the new unit. The two bulbs cost me around $4.80 at Napa. Just twist to remove:
http://img166.imageshack.us/img166/1518/pc090029zm4.jpg

Plug the unit back in, push the lever down, and push the unit back into the console. Once you hear the unit click into the console you can put the faceplate back on. Push it on until it snaps into place. Here it is installed, looks much better huh :) :
http://img184.imageshack.us/img184/9220/pc090030gg1.jpg


Hope you get good results!

[RED IS 91]

very nice .......... I can use this when I change my burnt out dashlight bulb.
Thanks

[Zoso]

Ah yes, a fresh clock! Mine was cracked when I bought my 318 too.

The replacement part was nice until it started to make random characters that can be described best as the Predator countdown to self explosion sequence.

I then replaced mine with the full OBC which I like much better.

Nice work though and thanks for the writeup.

[Alpine003]

The replacement part was nice until it started to make random characters that can be described best as the Predator countdown to self explosion sequence.


I had this too and that was exactly my first thought. I was waiting for the car to blow up or something.:D

[D. Clay]

The crazy characters are the result of a bad connection between the display and whatever the other end of that ribbon thingie connects to. I read on another forum that the way to fix this was to disassemble the unit and clean the ribbon connector and then put it back together. I cleaned it with soap and water and then high purity alcohol (not rubbing). It worked and has been good for about a year. Pay attention to the way it comes apart and goes back together. It comes apart real easy but the display has layers.

[maximus]

nice. i just replaced my clock the other day. had an almost identical bleed as the one you had.

looks awesome now. im a little skeptical about the accuracy of the temp readout tho.

[Febi Guibo]

Ah yes, a fresh clock!


seriously, the 6-button OBC pops out? seriously?!






seriously?!

[big red]

Thanks. Didn't realize it had bulbs. thought i'd have to start ripping the dash apart. It always pays off when I brouse the forums !!! Thanks again. I think I agree about the temp being out, maximus. Anyone else got thoughts (or answers)?

[Cobra Jet]

I'd like to know what causes the "LCD bleeding" that occurs. The original OBC in my 318ic was bad, looked like the one pictured above. Then, before I bought the car, the original bad OBC was replaced with another working used OBC... not even 2 months later, that "new/used" OBC is now doing the same as the original - it's bleeding again and the display is now fubarred...

Why do the 6-button OBC's go bad as such??

[EN318isPDX]

I'd like to know what causes the "LCD bleeding" that occurs. The original OBC in my 318ic was bad, looked like the one pictured above. Then, before I bought the car, the original bad OBC was replaced with another working used OBC... not even 2 months later, that "new/used" OBC is now doing the same as the original - it's bleeding again and the display is now fubarred...

Why do the 6-button OBC's go bad as such??

the damage to my OBC looks like it its from use.. its like a calculator screen.. the only way to break it is to press your finger hard on it.

[AcSchnitzer318is]

^What he said. I think this damage is usually caused by an inadvertent bump or knock of the screen. That's been the case on the 2 that I've seen go in friends cars.