Author Topic: Engine Loom Wires Please Help Me. (Read 2966 times)

Serge · « **on:** July 02, 2009, 09:50:57 PM »

As some of you may know I am in the process of replacing my head gasket, I am at a stage where I have hit a brick wall, I must of forgotten to label them.

Could somebody please verify where the big red terminal coming from engine loom to alternator then back again goes? maybe starter? and the two terminals for the starter one little and one a tad bigger, left, right etc.. help will be much appreciated. Serge.

ZeeGerman · « **Reply #1 on:** July 04, 2009, 01:26:56 PM »

starter and alternator.

end with triangel and red and blue wire goea to alternator. end with only red goes to same stud as red wire from bulkhead (on starter)

ZeeGerman · « **Reply #2 on:** July 04, 2009, 01:29:49 PM »

BTW, did you seperate the exhaust manifold from the pipe as bentley says or did you pull the exhaust headers from the head?

Serge · « **Reply #3 on:** July 04, 2009, 08:27:00 PM »

Thanks mate. I pulled the exhaust headers from the head only to have trouble during assembly as It's a struggle to put them back on. I think I'm going to have to seperate them from exhaust manifold from pipe. Some people pull the head off with the headers attached... let me know which route you will take. Serge.