« previous next »
Pages: [1]   Go Down

Author Topic: Input shaft torque specs for differential  (Read 2713 times)

aceofsnett

  • Newbie
  • *
  • Thank You
  • -Receive: 0
  • Posts: 8
    • View Profile
Input shaft torque specs for differential
« on: September 10, 2009, 01:08:34 AM »
I recently bought a 325is (big) diff for my 91 318is. I replaced all the seals, cleaned it, and will be painting it with por-15 before it goes in the car. My question is, what is the torque value for the input shaft nut? I don't want to damage the input bearing, or torque it past the crush value. Any help would be appreciated. Thanks in advanced.
Logged
1991 318is
1980 320i
1991 Hilux 3VZE/4WD
1994 Lebaron GTC Convertible
2009 Honda Fit Sport

RED IS 91

  • Hero Member
  • *****
  • Thank You
  • -Receive: 0
  • Posts: 981
    • View Profile
Input shaft torque specs for differential
« Reply #1 on: September 10, 2009, 04:24:34 AM »
Logged
[SIGPIC][/SIGPIC]

:D The Little Car That Could :D   214,000 miles :D

aceofsnett

  • Newbie
  • *
  • Thank You
  • -Receive: 0
  • Posts: 8
    • View Profile
Input shaft torque specs for differential
« Reply #2 on: September 10, 2009, 11:29:34 AM »
I appreciate it, but That... Doesn't really help. I didn't replace the bearing or crush sleeve, I'm simply putting the input flange back on. It is marked with yellow paint, maybe If I just snug it down and try to match that yellow paint it'll be fine. Anyone have any other ideas?

Quote from: RED IS 91;78195
Maybe this will help???

http://forums.bimmerforums.com/forum/showthread.php?t=931518
Logged
1991 318is
1980 320i
1991 Hilux 3VZE/4WD
1994 Lebaron GTC Convertible
2009 Honda Fit Sport
Pages: [1]   Go Up
« previous next »