Author Topic: '90 m42 into '84 318i(m10) (Read 3568 times)

vagrant_mugen · « **on:** August 28, 2008, 10:17:38 AM »

i just scored an m42 out of a 1990 318i. i want to drop it into my 1984 318i to replace the tired m10.

i dont want to swap the entire chassis harness out though.

i need to find a scimatic for the ecu harness wiring plug that connect to the fuseblock(15pin round on firewall) so i can wire just the engine into my existing fuseblock.

is this possible???

thanks for any/all help

kowalski · « **Reply #1 on:** August 28, 2008, 12:33:27 PM »

don't double post, if its going to get answered it will get answered, don't put it in two places.

your answer is probably here.

vagrant_mugen · « **Reply #2 on:** August 31, 2008, 10:01:39 PM »

thank you. and sorry about the twin post, wasnt sure how big these forums were.

my buddy is gonna get me wiring diagrams of the 2 cars, he works at a garage, i think they have a computer program with a huge index of every kind of car...

so hopefully i can get this motor swapped in and up and running. turning it over by hand the motor feels very tight, like it has good compression. gonna do a comp. test and see what shape she's really in.

vagrant_mugen · « **Reply #3 on:** September 04, 2008, 12:10:09 AM »

okay, didnt get anywhere with that link.

but, my friend works in a garadge and they have a computer program of wiring scimatics, so hes gonna get me the scimatics for the ecu harness/fuseblock connectors, so i can figure out what goes where.

ill tryin scan the scimatics, or write out the splices so others can have the m42 without re-wiring the entire chassis.