Author Topic: 318is blown gearbox will 318 z3 box fit (Read 2915 times)

elijah · « **on:** January 30, 2010, 01:11:26 PM »

if not then do you know of any others:confused:

nicknikolovski · « **Reply #1 on:** January 31, 2010, 12:39:08 AM »

Z3 1.8/1.9 uses the same gearbox as the E36 318is (Getrag 250) but different shifter arm and shift lever mechanisms. I believe the Z3 uses a short shifter set-up.

elijah · « **Reply #2 on:** January 31, 2010, 07:48:03 AM »

its an e30 that i have but i think the engine is the same bar the inlet manifold can i use the z3 gearbox and shortshift set up on the e 30 thanks

nicknikolovski · « **Reply #3 on:** February 01, 2010, 02:25:35 AM »

I own an E36 but I believe you can put the Getrag 250 into an E30 so I would say yes.

elijah · « **Reply #4 on:** February 10, 2010, 01:23:41 PM »

on the bell housing side of the box there is a spline shaft and on the end there is a spiget to line up with a bearing the new one is bigger than my old one can u change the bearing inside the engine very easily

tjts1 · « **Reply #5 on:** February 10, 2010, 02:08:42 PM »

The gear ratios are totally different. You will have to swap your diff.