Show Posts
1
Engine + Driveline / Re: e90 coils for M42 COP conversion
« on: January 09, 2020, 08:12:55 PM »
Thinking of doing this to my 95 318ti (m42) with Turner/Conforti chip and “Fogged”.
Wondering what you used for your wiring harness or did you make your own?
I’m planning to make my own using:
Male pin terminal #12521718125
Plug housing #12521718126
Lock Ring #12521718127
Male Pin Wire Connector #61131376193 1.0-2.5mm
To connect this to my existing ignition coil pack harness so if this COP does not work I haven’t destroyed any of the original wiring harness.
Then I was going to use the socket shown #12527519996 for connection to each ignition coil.
Any additional help is appreciated.
Wondering what you used for your wiring harness or did you make your own?
I’m planning to make my own using:
Male pin terminal #12521718125
Plug housing #12521718126
Lock Ring #12521718127
Male Pin Wire Connector #61131376193 1.0-2.5mm
To connect this to my existing ignition coil pack harness so if this COP does not work I haven’t destroyed any of the original wiring harness.
Then I was going to use the socket shown #12527519996 for connection to each ignition coil.
Any additional help is appreciated.