Messages

1

For Sale / M42 E21 built by Tom D + M42 parts

« on: July 18, 2017, 06:02:34 PM »

CAR:
http://phoenix.craigslist.org/evl/cto/6204526337.html
PARTS:
http://phoenix.craigslist.org/evl/pts/6225610106.html

Can include parts with car.

Reach me at 8317609823, Evan

2

Engine + Driveline / Re: Cam's timed 180Degrees incorrectly

« on: February 28, 2016, 07:00:14 PM »

Thanks for the responses guys, I didn't have the equipment to perform the leakdown test, so what I did was take measurements from piston position compared with opened/opening valves, then compared those to the spare head, from the best i could tell, I had it timed just so that all the valves and pistons were just missing contact with each other. That was a relief... but i decided to change the heads anyways, for a few reasons, the spare head was fresh from the machine shop, and it was in overall better condition than the one that was on. So now i've got my good head back on the car, timed perfect, running great. I haven't really scrutinized this head which was mistimed, but the valves appear to be correct to the passing eye.

3

Engine + Driveline / Cam's timed 180Degrees incorrectly

« on: February 25, 2016, 03:27:10 PM »

Hello,
I've done a head swap and a full engine build with the m42 before, and this last time when i was changing a head, i was too much in a rush and hastily mistimed the cams. From TDC on cylinder 1 the cams are 180degrees off (dots on the lobes are pointing down). I am prepared to take it off, as i have another spare head, but before doing so, I was wondering if anybody could confirm or deny whether or not i would have bent some valves.

I didnt realize the mistake until after having it all together and trying to start it, then removed the valve cover and realized the error.
initially when trying to start, it was making a pretty bad tapping noise, i thought it could have been the lifters pumping up with oil, but now i think it could have been the valves bending themselves out of the way of the pistons. visually i cannot see.

any insight? thanks