1
Engine + Driveline / connecting rods
« on: September 15, 2014, 08:58:42 PM »
Is it true that the m42 came with forged connecing rods? Read it some where and am very curious. Will help with my build.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General Topics / Re: E30
« on: August 30, 2014, 06:37:06 PM »
I was wondering about like aftermarket suspension and certain. Interior parts that may be easier to find because aftermarket parts for the 318 are not the easiest to find. And a lot of my interior is bad.
3
General Topics / E30
« on: August 27, 2014, 05:05:32 AM »
Do a lot of parts bolt up across model type? I have a 318is and i was wondering if suspension bolted up from a 325i? I'm talking after market. and how would i figure this out?
4
Engine management / Re: 1991 318is Cooling help.
« on: August 22, 2014, 04:56:51 PM »
Alright. so my gage when no power too it sits lower than yours. but i drove it around and such it ran fine never got hot. but then my fan clutch went out. so i replaced it and now it gets hot again, what should i do?
5
Swaps, Turbos, Buildups / Re: Interest in Bolt on Turbo kit?
« on: August 21, 2014, 01:43:04 PM »
Id buy in a heart beat
6
Electrical / Fuse Box
« on: August 21, 2014, 01:35:49 PM »
Can someone post a pic of their 318is fuse box? i need to compare, Ive been having issues with finding a good pic.
7
Engine management / 1991 318is Cooling help.
« on: August 19, 2014, 11:46:29 PM »
Alright guys, Im a noob to the forum so please be nice. So i am having a small issue with my cooling system, so when it gets warm the temp gage will sit right above the 50% mark, like an 8th between 3/4s and 1/2. I have replaced radiator water pump and t-stat. i have also done a coolant flush. And i spent countless hours to figure out how properly bleed the system so yes i believe i did it properly. only coolant comes out when i open the bleed screw. And i had a master mechanic look at the clutch fan and he said it was in perfect condition. is it okay if my temp gage and temp sits where it does? or is there something else i can do?
Pages: [1]