Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - chapellej

Pages: [1] 2 3 4
1
For Sale / Parts For sale
« on: July 29, 2013, 03:49:45 PM »
I no longer have an m42 engined e36 and have a couple of parts laying around.
cosomo racing strut brace for m42 $75 plus shipping
and a cosomos cold air intake kit with bracket for m42 $40

i can send pics please private message me and i can email you the pics.

2
Interior / CD43 Head Unit & Audio Amp Fundamentals - A Primer [LONG]
« on: October 30, 2012, 11:09:40 AM »
I want to know if its possible to wire the cd43 to run an aftermarket amp.

3
For Sale / M42 intake and plenum
« on: November 27, 2011, 02:46:53 PM »
I have for sale an intake manifold complete with a brand new gasket $60 plus shipping. I can provide pics if needed. I will ship to anywhere.

4
Swaps, Turbos, Buildups / ASA supercharger
« on: August 06, 2011, 09:27:33 PM »
So i can get an ASA supercharger kit for very little money complete, the catch is that it is for an e36 325. Now i am sure i can fit everything no problem but my question is what about software. What will i need to do with my current ecu which is chipped now. Any suggestions would be greatly appreciated.  


E36 318i m42


James

5
For Sale / e36 parts
« on: July 12, 2011, 06:39:12 PM »
I have the following items for sale, if you would like pics please let me know and I will email pics.

For sale

M52 coil cover in excellent shape - $20
M52 throttle 128,500 km’s - $ 40
M42 intake and plenum (painted red) with brand new gasket - $40
E36 steering wheel with air bag excellent shape 7/10 leather - $60
E36 airbag control module - $40
M tech three spoke steering wheel no airbag 7/10 condition $120
E36 328i diff 3.91 ratio $100 (will ship at buyers expense)
E36 black dash in mint $200 (will ship at buyers expense)
11 Button obc (some pixels gone) $15
M52 328i injectors (6) $25
E36 lug bolts (security with key) $30
E36 328i DME $60
E36 trailing arms with half shafts ( 2) $60 each




I can ship any and all items however you as the buyer will be responsible for shipping if shipping fees apply. PM works the best!!!!!!!

6
Electrical / e36 no start
« on: May 26, 2011, 06:29:38 PM »
problem solved, the wire that runs to the starter from the harness below the intake was broken and thus was causing intermitant starting thanks guys for giving me support and ideas!!!!!

7
Electrical / e36 no start
« on: May 22, 2011, 11:44:05 AM »
am geting fuel for sure so no gas smell, and the ignition switch is new. I hot wired the car and it started before replacing the ignition switch. I replaced it and the car started no problem. I drove it for about half an hour and then it wouldn't start after then it started and the same the next day. Got a boost and it fired up, and now it is dead again the battery is fully charged and i am getting 14 v when i try and start, the relays click also when i turn the ignition, i am going to pull all the intake off again ( for the hundredth time) and check my starter wiring as well.

8
Electrical / e36 no start
« on: May 20, 2011, 09:43:50 AM »
i am going through all the wiring today to see, i will update later this is so fustrating. Car sat all winter and now this...... booo

9
Electrical / e36 no start
« on: May 19, 2011, 06:43:49 PM »
also to add the alternator is used from an 88,000 km car, but a bad alternator would not cause the car to not start would it?

10
Electrical / e36 no start
« on: May 19, 2011, 06:41:35 PM »
battery is fully charged and the ground strap bad but used shrink tube to reseal it. What i dont get is that it started and ran fine then no start. I get a boost and it starts and then today same deal no start.

11
Electrical / e36 no start
« on: May 19, 2011, 05:23:57 PM »
i did wash the car but the dme is dry as a bone, and i was always wondering if there is an some sort of inhibitor that would prevent the car from starting but my car is a manual not auto.

12
Electrical / e36 no start
« on: May 19, 2011, 02:01:11 PM »
My 92 e36 318i does not start, i replaced the starter, alternator, and ignition switch. When i turn the key nothing, all the lights and everything works just no start, i got the battery tested and its good. It did start and ran fine then i went to work and nada. Got a boost and it started. So i go to start it today and same deal no go..... any ideas guys?

13
For Sale / FS: S50 Pistons and Rings
« on: May 07, 2011, 10:34:18 AM »
Quote from: Warsteiner;103613
Recipe for S50 pistons: Bore block to 86mm, get M44 2.04mm HG, Deck the piston 2.65mm, cut valve reliefs into pistons, get a set of 138mm connecting rods, attach to a M47 crank and away you go! A perfect set up. Minor machining on the crank.

Then you have to option of lightening valve train parts and porting the head for power.

A major write up coming soon....

Cheers,
~Ralph


suscribed!!!!

14
For Sale / FS: S50 Pistons and Rings
« on: May 06, 2011, 11:25:14 PM »
what would i need as far as head gasket, and crank to use these i am sure this can be searched but would a m47 crank work? and mls head gasket for deck clearance at the top? i am very interested in this.

15
For Sale / M42 Engine, 4.27 diff, driveshaft, engine accessries,
« on: April 28, 2011, 12:08:53 AM »
would you sell just the alternator and what is it bosch or valeo 105 amp.

Pages: [1] 2 3 4