Messages

1

Engine + Driveline / Value Throttle valve switch - E30 - 318IS

« on: March 27, 2008, 12:17:51 PM »

Hello everyone

I am busy with my friend has tested the value of the resistance mounted on the butterfly shaft of air (Throttle valve switch) (E30 BMW 318IS).

The piece is the number 2 :
http://bmwfans.info/original/E30/2-T/318is-M42/ECE/L/M/1990/03/mg-13/ill-13_0309/#1

The value of the resistance is 1200 ohms (completely closed)
The value of the resistance under full load is 7200 ohms (full opening)

When support is hard on the pedal the value of the resistance increases directly to 3000 ohms.

We test it, because when you press just on the accelerator, the system reduces to 600 rpm then reaches the desired value

Note: idling is stable at 900 rpm.
The vehicule accelerates normally except that when we want to stabilize the speed there to stop engine (Blows engine, vroum , vroum vroum if full accelerate, the motor Working properly

What do you think, is it right or change?

Thank you for your support

Fab318IS

2

Engine + Driveline / Measure value off a sensor camshaft

« on: March 21, 2008, 01:16:46 AM »

Hello,

Thank you for your reply.

Do you know the value of resistance of the sensor pulse?
Piece n°12  http://bmwfans.info/original/E30/2-T/318is-M42/ECE/L/M/1990/03/mg-11/ill-11_0156/

Me I measure 568 ohm

568 ohm for sensor pulse and 1568 ohm for sensor camshaft,
It should not have the same measure ?

Thank you

Fabrice

3

Engine + Driveline / Measure value off a sensor camshaft

« on: March 19, 2008, 11:31:28 PM »

Hello everybody,

I am Fabrice, i live from Belgium , i posses a bmw E30 - 318IS
I like this car ! (i don't find the presentation thred but i speak a little english )

I need your help for this next problem :

I have a question on sensor camshaft, the piece is registred as a number 6 :
http://bmwfans.info/original/E30/2-T/318is-M42/ECE/L/M/1990/03/mg-11/ill-11_2683/

How much does the resistance measure ?
I have measured and i find 1567 ohm.

i have measured between borne 1 and borne 2 with the multimeter

Can you help me pease?

Thank you very much

Fabrice