Show Posts

1

General Topics / bad idle

« on: October 08, 2008, 10:52:21 PM »

there is another dyno day commin up in November i believe. im hopeing to have a little more then last time.

2

General Topics / bad idle

« on: October 08, 2008, 01:47:07 AM »

Quote from: AcSchnitzer318is;58045

Checked the plugs for the icv and tps... pulled back the rubber and all that good stuff. All were good. Going to replace the complete exhaust system next and see if that has any effect...

you can swap cams with me if you want to try that...also if you want to swap out parts to help locate the problem i dont mind. ur the tall guy in SA right? your car is sick. im the guy with the white 318 we met on that dyno day...

3

Vendors / GB / EAT chip group buy for E30 M42!

« on: March 30, 2008, 02:35:50 PM »

well i got my car dynoed today and did 120hp and 110 torque. all i have is the 93octane chip and a m20 flywheel.. a cammed untuned m42 that was running on a stock chip did 116.he should have been much higher though.

4

Electrical / COP Brackets: Your Preferences?

« on: March 27, 2008, 05:51:30 PM »

Quote from: D. Clay;45396

Just fold them over themselves under the plastic cover on the firewall. I did that for about a month until I shortened mine. I never had any luck with the clips so I just cut a piece out of the wires and rejoined them
at the right length. It actually isn't necessary to shorten them at all.

sweet thanks man i want to have this on for the weekend.. i want to see a base dyno.. the losal club is having a dyno day

5

How-To's / DIY M20 flywheel conversion

« on: March 24, 2008, 10:41:36 AM »

well if i was to reuse my old tranny which was busted it had the smaller shaft and would have needed the m42 clutch tool. but for some reason the newer trans i got had the larger m20 shaft so i had to replace a couple things. we shaved the flywheel down and bolted the m20 starter right up. everything went together much easier then it came apart and the results were great.

6

Electrical / COP Brackets: Your Preferences?

« on: March 22, 2008, 11:42:33 PM »

damn how hard is shortening the wires ive had this sitting here forever but dont trust my wiring. could i keep them long then just wiretie the out of the way till i learn?

7

General Topics / Searched: M20 flywheel conversion Q

« on: March 21, 2008, 02:56:39 AM »

sorry for the old bump but up top i read the m20 starter will work fine if i dont use the spacer.. is this true? or do i swap everything out.. if i dont have to swap i wont.. my fly is getting cut down tomorrow so it should be on tomorrow night.
also the m20 TOB wont work or will it be fine.. i have both but if i can use the m20 TOB ill just return or sell the other

8

How-To's / DIY M20 flywheel conversion

« on: March 18, 2008, 07:00:51 PM »

i picked up some 22mm flywheel bolts are they going to be too short for me?

also was i supposed to get the m20 clutch tool? because i did. im hoping if it clears up outside tomarrow to get this knocked out.

9