Messages

1

Engine + Driveline / Gas pedal went out???

« on: August 30, 2012, 09:57:16 AM »

on the way home from school going a across the bridge i pulled over too take a picture and it was a bumpy/pot hole kinda road then my pedal went out. when i pushed it down it felt like there was nothing there. could that be a throttle cable im confused on this one and im missing school because of it HELP!!!!!

THANKS  
CHRIS

2

Exterior / skinny side moulding to thick moulding??

« on: August 11, 2012, 01:48:28 PM »

as you know the bumbers have the black moulding thats about 2inches wide but my door moulding are thin. is it posible to replace them with the more flat wide side mouldings???

3

For Sale / FS: M42 Parts Sale In Charleston

« on: August 05, 2012, 11:40:11 AM »

what about the coils??

4

For Sale / window motor/actuators, windows and harness.

« on: July 23, 2012, 09:47:25 AM »

do you still have the driver motor im in tampa and really need one

5

Engine + Driveline / idle control valve hose causing low idle??

« on: July 22, 2012, 07:09:08 PM »

the idle control valve hose was ghetto rigged by previous owner where they took the split end of the hose and connected it too the bellow with zip ties and had two seprate hoses coming off of it. Could that be causing low idle and sputters? its stays at 500 rpm or lil lower give or take

6

Engine + Driveline / What are these hoses for??

« on: July 22, 2012, 06:09:06 PM »

the piece that connects to the intake with the zip ties on it i  need a new on and does that piece come with the heater hose conected to it??

7

Engine + Driveline / What are these hoses for??

« on: July 22, 2012, 04:31:36 PM »

so i think i have a vacum leak but cant figure out where its at but something cuaght my eye right behind the intake. It almost looks ghetto rigged like all those hose clamps and zip ties in there and i would really like to find out what it look likes stock haha and what exactly are those hoses for?

8

Engine + Driveline / code for camshaft poistioning sensor?

« on: July 21, 2012, 02:43:56 PM »

i need the code for the camshaft poisition sensor is bad. my car idles at 500rpm and stalls out when cold  also alot of sputter!! just got this car today so trying to get it on the road fast as possible also if theres any good webs sites to find the sensor oem for cheap.