Messages - Ben Carufel
Quote from: xwill112x;65872
i used about 4 inches of 1/2" insulated heater hose(make sure its for high heat i melted one heated hose)...it's a bit hard to get it on the lower part, just put as bit of motor oil on your pinkey finger, and it should slide on down onto it, just with a little effort....then plug the other end on to the head.
so again,
about 1 foot (its sold by the foot here, so just cut it to like 4 inches or so) of the 1/2" insulated heater hose.
and 2 metal hose clamps
thats all.
oh and..dont forget to tighten everything down properly, and to bleed the system of any air when your done...or you'll be on red about 1/2 mile down the road.
Cool. So, 1/2" high temp heater hose.
As far as all the OEM parts, have you ever seen a list of part numbers that someone would need to order in order to complete the hose refresh/TB plate delete/etc?