M42club.com - Home of the BMW E30/E36 318i/iS
DISCUSSION => Engine + Driveline => Topic started by: e30Andym42 on May 25, 2009, 01:14:12 AM
-
I am removing my transmission. I have 9 torx bolts removed, and one hex bolt removed. The transmission slides back as it should, but wont go more than about 2.5 inches. I check and see that the starter is still magically connected to the tranny. It wont come off at all. I've tried all I could. I am completely out of ideas for this one. I checked the diagram on realoem.com and still nothing rang a bell for me. It will not come off.
What could I possibly be missing/forgetting?
-
there are two bolts and a guide pin that hold it in place, make sure both of the bolts are out then tap it with a hammer to get it off the guide pin