M42club.com - Home of the BMW E30/E36 318i/iS

DISCUSSION => Engine management => Topic started by: ThisIsTheRanger on March 13, 2009, 05:46:24 PM

Title: Replaced faulty sensor- CEL turned off but code remains
Post by: ThisIsTheRanger on March 13, 2009, 05:46:24 PM

I just replaced my AFM with a used one because I was getting code 1224-Intake Air Temp Sensor.  The check engine light went out as soon as I started it up again but when I check for codes with the stomp method, I still get code 1224.  Do I have to reset the computer to get the code to go away?  I tried unplugging all of the injection control fuses for a while to no avail.  I figure the new AFM has a working IAT because the light went out but what's with this code?

Title: Replaced faulty sensor- CEL turned off but code remains
Post by: JP 91iS on March 13, 2009, 06:30:53 PM

I remember reading about a way to clear the fault codes stored in the ecu. I don't remember how though. I would try disconnecting the battery for a few minutes.

Title: Replaced faulty sensor- CEL turned off but code remains
Post by: RED IS 91 on March 14, 2009, 04:01:20 AM

Disconnect the Battery for 30 minutes .This should reset the computer.

Title: Replaced faulty sensor- CEL turned off but code remains
Post by: ThisIsTheRanger on March 15, 2009, 11:07:28 AM

Thanks guys. That worked. I just didn't want to lose my stereo settings but for some reason they stayed. Now get code 1444 :)