M42club.com - Home of the BMW E30/E36 318i/iS
DISCUSSION => Engine + Driveline => Topic started by: scmooncake on January 30, 2009, 09:49:45 AM
-
Dear brother,
My car is 95 E36 M42 318IS AT. My engine can`t run above ~4500rpm...in either P,N and D shift. Is it had any prossible cases? I had already check the fault code (only 72 speed sensor problem). Many thanks for your kindly help!
-
What happens to it above?
Does it cut like it's hitting redline / fuel cutoff?
-
its prob a 325 gauge. they act like there redlineing at 4500, but there really at 6500...when put on a m42
your tach is probly just off a bit.
-
you need either a crankshaft sensor or theres probably an eninge speed sensor for the computer. mostlikly mounted on or around the transmision bell housing.
-
You can find one at Pelican Parts for $50.00.
-
It cut like it's hitting redline / fuel cutoff, anyway thanks to all of your kindly advise. i will check those possible cases !
-
I have had this issue with my car.
Replacing the Crankshaft position sensor and reseating the ECU connector solved it.
-
Dear roundel318
Thanks for your helpful info!!
Is it had any fault code?
-
If you need a replacement sensor, shoot me a PM. I just stripped a running motor.
-
That was part of the pain, I got no fault codes from it.
-
i think qiuene30 may be depressed....
sad sad story
-
I had a problem like that on my M3. Somebody had swapped a 6-cylinder engine cluster into the car, so the rpms read 2/3 of the actual value.