M42club.com - Home of the BMW E30/E36 318i/iS

DISCUSSION => Engine + Driveline => Topic started by: -Onz- on August 07, 2008, 09:03:35 AM

Title: m20 325i downpie and centre section on an "is"
Post by: -Onz- on August 07, 2008, 09:03:35 AM

Hey guys,  If I were to use the remus  4 into 2 stainless manifold followed by a stainless m20 dual downpipes and dual pipe centre section leading to a decent backbox would i loose or gain power from my "is" ?

Title: m20 325i downpie and centre section on an "is"
Post by: EN318isPDX on August 07, 2008, 10:37:34 AM

Quote from: -Onz-;54490

Hey guys,  If I were to use the remus  4 into 2 stainless manifold followed by a stainless m20 dual downpipes and dual pipe centre section leading to a decent backbox would i loose or gain power from my "is" ?

You may gain a couple horses if your lucky but honestly you would be better off getting just a high flow cat and a nice muffler. Our factory "header" is the nicest exhaust manifold I've ever seen come on any older car.

Title: m20 325i downpie and centre section on an "is"
Post by: -Onz- on August 08, 2008, 06:08:54 AM

so, i definately wouldnt loose power then?  Also could i use the standard manifold with a 1 into 2 pipe and use my stainless centre section?