M42club.com - Home of the BMW E30/E36 318i/iS
DISCUSSION => Engine + Driveline => Topic started by: m42 fan on December 03, 2006, 04:37:02 PM
-
Gentlemen,
Yesterday I installed my H&R OE/Bilstein HD setup (Looks and works great btw!). On my test drive, I noticed, for the first time, my clutch slipping. :mad: So, if I'm going to have to drop the Exhaust, Driveshaft, and Tranny, I want to make sure it only has to happen once. With that in mind, I'd like some suggestions as to what else I should be taking care of while I have the car apart. Thanks!
Brian
-
Rear main oil seal, guibo.... and maybe a lighter flywheel and short shifter.
-
Shifter: already in...
Guibo: Standing by...
Rear main seal: Good call, I'll have to pick one up...
Flywheel: Good idea, but it's not in my plans for the car. Either too expensive or a PITA, depending on which route you try and go.
Thanks for the ideas, keep 'em coming!
Brian
-
center support bearing; new guibo bolts; check the slave cylinder; rear shifter rod bushing thing; new o2 sensor... what else is down there?
give everything a good cleaning too...