M42club.com - Home of the BMW E30/E36 318i/iS
DISCUSSION => Electrical => Topic started by: 76m2002 on March 30, 2012, 04:39:17 PM
-
Can anyone tell me about the gray wire with black stripe in the picture? I had to remove the blower, and after reinstalling the blower, I'm putting the wiring harness back on to the top of the firewall. I discovered two gray wires with black stripes that have connectors that are clearly made for each other (yellow arrows in pic). However, one connector is wrapped with old tape in a direction opposite from the other, so they can not reach. Any idea what this is all about? I can't figure out if it's an option that is not installed in our car, or if something was hacked many years ago, and I should reconnect the two wires.
(http://dl.dropbox.com/u/2328398/318is/JPEG/wire%20copy.jpg).
Thanks for any suggestions,
Ian
-
There's a thread on here about "the hot start problem" that mentions this wire.
Leave the wire disconnected unless you have a Euro non-cat car.
-
Thanks!
-
O, yeah, thats the "run like crap " wire...dont hook it up, unless your car runs too good
Geoff