M42club.com - Home of the BMW E30/E36 318i/iS
DISCUSSION => Exterior => Topic started by: goober on January 03, 2011, 05:54:29 PM
-
16x7 4x100 +35 offset and BSM of 5.303
Because I dont know how to insert pictures, they are MSR style 068.
Any help is greatly appreciated
Thank you
-
http://www.1010tires.com/wheeloffsetcalculator.asp
Here's a good thread too:
http://www.maxbimmer.com/forums/showthread.php?t=54146
Stock rim (that's what I run) is a 14x6 with an offset of 35mm. Your wheel will be 10mm closer to the strut (about 3/8"), 16mm farther out. If I was in your shoes I'd be out there with a ruler to see how much room I had.
They seem a little close for (my) comfort, but a little rubbing isn't the end of the world. Spacers are pretty cheap (don't forget longer lug bolts too), so even if you make a mistake you're not totally out of luck.
-
Nice threads, I have checked out the second one however the first one is new to me. I'd prefer to have no rubbing whatsoever, however if I were to put say 215/40/16 on them, could I use them on my 318is without causing permanent damage? If there would be rubbing, should I get 10mm spacers? Thank you for your help, its really appreciated as I'm new to this.
-
depending on the tire size, YES. I would deff suggest at least a 15mm spacer. Like Dave said the rim itself will be 10mm closer to the strut and just over 1mm out past the old rim.
-
Sorry but what brand or make would recommend?
Thank you
-
I would stick with the big names. Tires are VERY important.
-Falken is prob the best bang for buck.
Good names, in no specific order
-Bridgestone
-Continental
-Goodyear
-Hankook
-Michelin
-Yokohoma
You can go outside these brands but I would not recommend it.
-
Ok thanks, I'll probably end up getting yokohamas. How about for the spacers, I've been looking at eibach, and do they need to have certain specifications I need to know about?
thank you
-
Just make sure they are 4x100 and are hubcentric to e30's (57.1mm)
-
Thank you very much for your help. Now for a pure aesthetic question...silver gloss? Or black?
Thanks
Btw, I have an alpine white 91
-
Personally I would either do a bronze or a gunmetal wheel. Can depend on the wheel though ;)
-
Well thanks for all of your help. I understand a lot more about e30 fitments and how to fit my car thanks to you guys. I'm actually considering a different wheel now, same measurements however, a little more of an offset, however I will put 15mm spacers. They look similar to the BBS LMs. Black mesh, and polished lip. I'll be sure to post pictures when I get them on.
Thank you